Category: Japan Car Key Programmer

Topic: Toyota Corolla LE 2005 key program when all keys are lost

Vin : INXBR32E35Z373232

It’s an 2005 model year.

Where can I locate immobiliser?
What is the transponder ID chip type?

Please help to program. Thanks

Good tip:  Transponder info is stored in the key ecu which relays information to the ecm.
it’s behind the dash.

Reply 1: you need Toyota techstream or mastertech Toyota tool to do all keys lost but you will need a seed code, have had some luck with launch to reset without seed code on those older ones.

Reply 2: There are many ways todo it that model year. Get the key ecu out and read the prom. Install a new key ecu. Buy a cheap programming device via many Chinese websites. Toyota Techstream and the list may go on.

Reply 3: Can successfully programmed with Autel maxidas 708

Reply 4: I have success with OBDSTAR X300 DP on Toyota Corolla 2010 G Chip. Maybe you can have a try.

EIDT: I checked the menu this morning, your Collora ‘2005 is listed

Upload pictures here:

Connect OBDSTAR X300 DP key Master via OBD:
Select IMMOBILIZER

Select Toyota

Select Toyota/Scion/Lexus V31.11
Select from vehicle, press OK

Select vehicle make: Toyota

Select Toyota Region, for example Asia

Select Toyota model: Corolla

Select model year:2010-

Select Immobiliser

Select key chip type: Type 1(With G 72)
Select function: Reset immobiliser (All keys lost)

Switch ignition off
Switch ignition on
Switch ignition off and remove the key
Switch ignition on
Switch ignition off and remove the key

The system pops up the tutorial of key programming with X300 DP Obdstar:

“program keys as the following steps within 120 seconds:

A: program 2 master keys and 1 sub key

1- program the first master key, turn on the ignition and wait for 5 seconds

2- insert the second master key, turn on the ignition switch and wait for 5 seconds

3- insert the third sub key, turn on the ignition switch and wait for 5 seconds. The security light turns off and programming is finished.

B: program 1 master key (here, we should follow this guide)

1- insert the first master key, turn ignition on and wait for 5 seconds”

2- insert the second sub key, turn on the ignition switch and wait for 5 seconds

3- turn on the ignition switch quickly for 5 times. The security light turns off and programming is finished.

C: program 1 master key:

1- insert the master key, turn on the ignition switch and wait for 5 seconds

2- turn on the ignition switch quickly for 5 times. The security light turns off and programming is finished.”