VVDI2 programs VW MQB NEC35XX smart keys by following the step-by-step procedure.
2) Original blank key or MQB key made by VVDI2
3) MQB Immobilizer function Authorization (User who hase the copy 48 (96 bit) authorization will get MQB license for free)
Open VVDI2 V5.1.0, select the option “VAG”
The computer is communicating with the device, please wait…
Turn on the dashboard
Click on “Read EEPROM/FLASH”, then NEXT.
Picture means “Note: EEPROM needs to be read out for one time, the general user doesn’t need to read out the FLASH which only supports a part of dashboard and will read for a long time.
Follow the tip “After using the original working key to turn on the ignition, click “OK”. If it is keyless entry system, please put the original working key close to the sensor coil and turn on the ignition. ”
Click on “OK”
This is Smart key, click on “OK”
Reading data, please wait…Both the EP data and IMMO data need to be read out.
Read ep data successfully and save as name “ep”
Please read the prompt: After the operation complete totally, please click on the option “Restore the dashboard” to active the dashboard.
Click on “Read IMMO data“, read successfully and save as name “fd”.
Follow the tip: After the operation complete totally, After the operation complete totally, please click on the option “Restore the dashboard” to active the dashboard, click “OK”
Save IMMO data successfully
Click on “restore the dashboard” and you can see restore successfully.
Follow the tip “Use the original working key to turn on the ignition switch, click on “OK”, if it is keyless entry system, please put the original working key close to the sensor coil and turn on the ignition.”, click on “OK”.
Are visiting safely
Before generating dealer key, firstly read the original key.
Get the long message shown as below, Click on “ok”
Generate common dealer key, click on “Next”.
Get message “Warning: the dealer key that is generated with the original key can’t be replaced the Anti-start lock online, otherwise the following ECU will be affected:
17- Combined dashboard
19- gateway system
2B – electronic steering column lock
Advise you choose the option “OEM” to generate the OEM dealer key.
Go on generating the common dealer key?
Click on “Yes” to continue.
Are you sure you want to generate Audi common dealer key?
Please make sure the make is right, if you choose wrong, please return back to choose again.
Click on “Yes”
Put the original key into the VVDI2 antenna then click on “OK” to confirm.
Please input the new key into the VVDI2.
The dealer key generates successfully, please learn it to the car (2 pieces to learn).
Get message: After the operation complete totally, please click on the option “Restore the dashboard” to active the dashboard.”, click “OK”
Click on “Add key”
Get message “Note: before learning the key, please firstly save EEPROM and IMMO data (Important), if it saved please go on…”
Enter the number of dealer keys you want to learn? enter “2”, then click on “Load the IMMO data”, choose “fd” file, click on “Next”
Message ” the current key is smart?”, click on “Yes”
Put the first key close to the sensor coil of the car, turn on the dashboard and go on.
The first one key is learned successfully, you can see 1-2 on the dashboard.
To learn the second key.
Put the second new key close to the sensor coil of the car.
Learn succeed, you can see 2- on the dashboard.
You see the left corner status ” learn succeed”
This is the new key which is programmed, test the remote works.
Take the original key out of the car, to start.
Finally! VVDI2 programs VW MQB NEC35XX system smart keys successfully.